23
the car, is appropriately tensioned and
untwisted.
• Do not leave the car unattended
when the child is seated in the child
car seat: watch your child even when
he is asleep.
• Never leave a child alone and
unsupervised in a car, not even for
a short time. The temperature inside
the vehicle can change rapidly and
become dangerous for the child inside.
• Never remove the child from the seat
when the car is moving.
• Verify that the child car seat is not
obstructed by a moving part of the
seat or a door.
• Adjust the height and tension of the
belts, verifying that they adhere to the
body of the child without exerting
excessive pressure. Verify that the safety
belt is not twisted and the child cannot
unfasten it.
• Do not leave the car seat in the car
if exposed to direct sunlight, because
some parts could overheat and cause
injuries to the delicate skin of your
child. Verify that the seat is not too hot
before seating your child.
• Do not use the child car seat without
the lining. This lining cannot be
replaced by another lining that has
not been specifically approved by the
manufacturer because it is an integral
part of the seat and is essential for
safety purposes.
• Do not remove or replace the white
polystyrene part under the seat, in the
backrest and in the headrest, as it is
essential for safety purposes.
•
In case of doubts, contact the manufacturer
or retailer of this child car seat.
• This item has a progressive serial
number.
• Do not remove the adhesive or sawn
labels. The removal of these labels
could result in the product not being
compliant with standards.
• Do not use the child car seat if it is
broken or if there are missing parts, or if
it has been subjected to heavy impacts
as a result of accidents, as it may have
suffered structural damage which is not
visible but is extremely hazardous.
• If using a second-hand product, make
sure it is a recent model, comes with
instructions, and is fully functional in
all parts. An obsolete product may
not conform to safety standards, due
to natural ageing of materials and
updating of regulations. If you have
any doubts, contact the manufacturer’s
customer service centre.
• Do not alter the product.
• Contact the post-sales service for
reparations, the replacement of
components and information on the
product.
Refer to the last page of this manual for
further information.
If the child car seat has been fixed in
place with Isofix fittings, do not detach
it from the fittings.
If the car seat has been fixed in place
with safety belts only, it is possible to
remove it and store it in the luggage
compartment if unused.
• Do not use accessories that have not
been approved by the manufacturer or
competent authorities.
1_ IMPORTANT
• "Viaggio 2/3 Surefix": this car seat,
group 2/3, must be installed in the
direction of travel.
• Do not install “Viaggio 2/3 Surefix”
in an opposite or transversal location
as compared to the direction of
travel.
• It is always advisable to fit the child
seat on the rear seats and on the
passenger’s side.
• If the child seat is installed on the
front seat, it is advisable to place it as
far as possible from the dashboard.
If you experience problems during
the installation of Viaggio 2/3
Surefix, try lifting the headrest
without removing it.
Components of the product
2. Inspect the content of the package
and contact the Customer Care if some
items are missing.
_ The child car seat includes: 1 headrest
(a), 1 backrest (b), 1 seat (c).
Backrest and headrest are factory
assembled. To assemble correctly the
product please follow the instructions
carefully.
Product assembly prior
to use
3. Rotate the red stops in the open
position and slide the backrest in the
housings located behind the seat as
shown in the picture.
4. Keeping the product flat, close the
red stops until a click is heard.
To Next Page
Loading...
Need help?
General
