Pego EASYSTEAM - Programming and Configuration; Nano EasySTEAM Display Description

Rev. 01-16 Page 31
MANUALE D’USO – USER MANUAL
NANO EASYSTEAM DISPLAY DESCRIPTION
The NANO EasySTEAM display is normally found on the front of the humidifier. It is made of a 3-
digit display and 9 luminous icons for visual control of the sizes and 4 keys for displaying choice
and settings amendment (fig. 25).
Fig. 25

UP / DISPLAY KEY
- In programming: Increases values/Scrolls parameters upwards
- From main display: Selects display in: "absorbed current (A)", "steam output % (%)"
and if S9=1 or 3 "Ambient humidity display (%RH)".
Every time it is pressed, it changes to successive display.

DOWN / MANUAL WATER DISCHARGE KEY
- In programming: Decreases values/Scrolls parameters downwards
- From main display: Activates the water manual discharge

STAND BY / SILENCE
- Pressed for more than 2 sec. alternates the Stand-by status to normal functioning
status, and vice-versa. A confirmation beep is emitted upon occurred change-over.
- Silences the audio alarm if present / Acquires an alarm

SET (active with S9=1,3,5,6)
- Displays set point when pressed and when released "Ambient humidity display
(%RH)"
- Enables setting the %RH set point if pressed together with the Down or UP key
- Restores audio alarm, if present.

DISPLAY

STAND-BY 4 ICON
LED OFF = Humidifier not powered
LED ON = Humidifier ready for use
LED Flashing = Humidifier in stand-by

STEAM OUTPUT ICON
LED ON = Steam output in progress
CHAP. 3 PROGRAMMING
3.1









