Peimar Virtus PSI-J4000-TP User Manual

94
EN
If this error occurs frequently, please contact your DNO or contact
Peimar assistance.
Relay Error
Check whether the radiator is blocked, whether the inverter is in too
high or too low temperature, if the above mentioned are in normal,
please contact your DNO or contact Peimar assistance.
Temperature High Error
If this error occurs frequently, please contact your DNO or contact
Peimar assistance.
Storer Error
If this error occurs frequently, please contact your DNO or contact
Peimar assistance.
GFCI Device Error
If this error occurs frequently, please contact your DNO or contact
Peimar assistance.
DCI Device Error
7.2 Fault Information and troubleshooting
Check the set of country and check the frequency of the local
grid, if the above mentioned are normal, please contact your DNO
or contact Peimar assistance.
Frequency Error
Check the connection status between the AC side of the inverter
and the grid, if the above mentioned are in normal, please contact
your distributor or contact Peimar assistance.
No Grid Error
If this error exists always, please contact your DNO or contact
Peimar assistance.
DCI Error
• Check the volt of the grid.
• Check the connection between the inverter and the grid.
• Check the settings of the on-grid standards of the inverter.
• If the voltage of the grid is higher than the standard value,
please conctact the Distribution Network Operator (DNO) for
the adjustment at the feed point or for the modication of the
regulated voltage value.
• If the volt of the grid is in regulated range as allowed and
LCD still in this error, please contact your DNO or phone
Peimar.
AC Voltage Error
If this error occurs frequently, please contact your DNO or contact
Peimar assistance.
Current Sensor Error

Peimar Virtus PSI-J4000-TP Specifications

General

Brand	Peimar
Model	Virtus PSI-J4000-TP
Category	Inverter
Language	English