Why is the water pressure slowing down in my Pelican Water Dispenser?
If you notice the water pressure slowing down in your Pelican Water Dispenser, it might be time to replace the Sediment Filter. It's generally recommended to replace this filter every 6-9 months, depending on how much sediment is in your water. Inspect the Sediment Filter and replace it if needed.
How to fix water leaking at the top of the tank of Pelican Water Dispenser?
If you notice water leaking at the top of the tank around the head of your Pelican Water Dispenser, try tightening the head. The tank head comes pre-installed hand-tight. Be careful not to overtighten it; just turn it until it's snug.
What to do if the Pelican Water Dispenser tank leans to one side?
If the tank of your Pelican Water Dispenser leans to one side or isn't level, lift the tank straight up about 6 inches. Then, gently tap it on the ground until the tank stands upright. The bottom of the tank is round, and the boot helps it stand vertically.
Key instructions and code compliance checks before installation.
Detailed instructions for installing the bypass valve assembly.
Step-by-step guide for assembling the sediment filter components.
General| Brand | Pelican |
|---|---|
| Model | NaturSoft NS6 |
| Category | Water Dispenser |
| Language | English |
To Next Page
