What to do if my Pelican PS48 Water Dispenser system is backwashing but not using salt?
If your Pelican Water Dispenser system is backwashing but not using salt, it might be due to salt bridging. This occurs when too much salt is added, forming a solid block. To resolve this, shake the brine tank until the salt block breaks apart.
Why does the Brine Tank of my Pelican PS48 Water Dispenser have too much water?
If the brine tank in your Pelican Water Dispenser has too much water or isn't filling properly, check all the fittings on the brine tank and electronic head. Make sure they are tightened to prevent air from getting into the brine tank hose.
How to fix a Pelican Water Dispenser tank that leans?
If your Pelican Water Dispenser tank leans to one side or isn't level, lift the tank straight up about 6 inches and gently tap it on the ground until it stands vertically. Note that the tank's bottom is round, and the boot helps it stand upright.
How to stop water leaking from the top of my Pelican Water Dispenser?
If you notice water leaking at the top of the tank around the head of your Pelican Water Dispenser, try tightening the head. It's pre-installed hand-tight, so just turn it snug. Avoid overtightening.
Key setup and safety guidelines for system installation and operation, including warnings and cautions.
Steps and considerations before beginning the physical installation of the water softener.
Detailed instructions for connecting and setting up the bypass valve to the softener.
Guide on attaching and securing the electronic control head to the softener tank.
Guides the user through initial valve settings on the electronic head for the softener.
Procedures for accurately setting the current time on the electronic control unit.
How to initiate a manual regeneration cycle for the water softener.
General| Brand | Pelican |
|---|---|
| Model | PS48 |
| Category | Water Dispenser |
| Language | English |
To Next Page
