What to do if my Pelican PS80 system is backwashing but not using salt?
If your Pelican Water Dispenser system is backwashing but not using salt, it might be due to salt bridging. This occurs when too much salt is added, forming a solid block. To resolve this, shake the brine tank until the salt block breaks apart.
Why does the Brine Tank of my Pelican PS80 Water Dispenser have too much water?
If the brine tank in your Pelican Water Dispenser has too much water or isn't filling properly, check all the fittings on the brine tank and electronic head. Make sure they are tightened to prevent air from getting into the brine tank hose.
How to fix a Pelican Water Dispenser tank that leans?
If your Pelican Water Dispenser tank leans to one side or isn't level, lift the tank straight up about 6 inches and gently tap it on the ground until it stands vertically. Note that the tank's bottom is round, and the boot helps it stand upright.
How to stop water leaking from the top of my Pelican PS80 Water Dispenser?
If you notice water leaking at the top of the tank around the head of your Pelican Water Dispenser, try tightening the head. It's pre-installed hand-tight, so just turn it snug. Avoid overtightening.
Preparation and considerations before beginning the main installation process.
Instructions for correctly attaching and setting the bypass valve mechanism.
Detailed steps for connecting the electronic control head to the softener tank assembly.
Guide for setting the clock, valve parameters, and regeneration settings on the control unit.
Coverage for tanks, valves, media, and housings under normal use.
Coverage for retention tanks and solid-state electronic heads.
Exclusions, owner duties, liability limits, and registration requirements.
Specific performance guarantees for PC600 and PC1000 filter models.
General| Brand | Pelican |
|---|---|
| Model | PS80 |
| Category | Water Dispenser |
| Language | English |
To Next Page
