8
NOTICES
This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) this device must not cause harmful interference,
and (2) this device must accept any interference
received, including interference that may cause
undesired operation.
NOTE: This equipment has been tested and
found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable
protection against harmful interference in a
residential installation. This equipment generates,
uses and can radiate radio frequency energy and,
if not installed and used in accordance with the
instructions, may cause harmful interference
to radio communications. However, there is no
guarantee that interference will not occur in a
particular installation. If this equipment does cause
harmful interference to radio or television reception,
which can be determined by turning the equipment
off and on, the user is encouraged to try to correct
the interference by one or more of the following
measures:
1 Reorient or relocate the receiving antenna.
2 Increase the separation between the equipment
and receiver.
3 Connect the equipment to an outlet on a circuit
different from that to which the receiver is
connected.
4 Consult the dealer or an experienced radio and TV
technician for help.
CAUTION:
1 To comply with FCC RF exposure compliance
requirements, a separation distance of at least
20 cm must be maintained between the antenna
of this device and all persons.
2 This transmitter must not be co-located or
operated in conjunction with any other antenna or
transmitter.
Waste electrical products must be handed over
to a designated collection point for disposal
to be recycled in an environmentally sound
manner. Improper disposal of this product
could result in harm to the environment or to
human health. Check with your local waste
authority or the retailer where you purchased
this product for available collection facilities or
further recycling advice.
Please avoid the generation of waste from
electrical products as much as possible,
e.g. by giving preference to products with a
longer service life or by reusing used electrical
products instead of disposing of them.
You are responsible for deleting any personal
data from this product before disposing of it.
This product is ANT+™ certied and is
compatible with ANT+ sensors that support
heart rate monitoring.
To Next Page
Loading...
Need help?
General
