Pelpro PP130 - Glass Specifications; Electrical Rating (on High); BTU & Efficiency Specifications; Stove Dimensions

PelPro Pellet Stove • 7104-171C • 10/3/18pelprostoves.com
37
Listing and Code Approvals
Listings and Certications
Glass Specications
This Stove is equipped with 5mm ceramic glass.
Replace glass only with 5mm ceramic glass. Please contact PelPro for replacement glass.
Electrical Rating (On High)
PP130-B: 120 VAC, 60 Hz, Start 2.6 Amps,
Run 2.3 Amps
This manual describes the installation
and operation of the Brand PelPro,
Model PP130-B wood Stove.
This Stove meets the 2020 U.S.
Environmental Protection Agency’s
crib wood emission limits for wood
Stoves sold after May 15, 2020. Under
specic test conditions this Stove has
been shown to deliver heat at rates
ranging from 9,605 to 40,637 Btu/hr.
BTU & E󰀩ciency Specications
Emissions Report No. 0135PS041E
EPA Certicatin # 128-18
EPA Certied 0.53 grams / hr
*LHV Tested E󰀩ciency 87.5%
**HHV Tested
E󰀩ciency
81.9%
***BTU Output 9,605 - 40,667 / hr
****BTU Input 11,676 - 49,207 / hr
*****Heating Capacity
1,225 to 2,500 sq. ft.
depending on climate zone
Vent Size 3” or 4” L or PL
Hopper Capacity 130 lbs (Approximate)
Fuel Premium Wood pellets
Shipping Weight 265 lbs
2-1/2
[64]
4-1/2
[114]
24-1/2 [622]
36-1/2 [902]
24-1/2 [622]
22-3/4 [578]
8-1/4 [210]
AIR INLET
9-1/2 [241]
FLUE
Stove dimensions
*Weighted average LHV e󰀩ciency using data collected during EPA emissions test.
**Weighted average HHV e󰀩ciency using data collected during EPA emissions test.
***Maximum BTU output based on HHV e󰀩ciency and the high burn section of the EPA emissions test.
****Maximum BTU input based on the high burn section of the EPA emissions test.
*****Heating capacity depencs on climate zone, structure layout, insulation, windows, etc.
Stove Dimensions