PP60 TROUBLE SHOOTING MANUAL
8-5-2013
1 FLASH: EMPTY HOPPER
UNPLUG UNIT, CLEAN FIREPOT AND MAKE SURE IT IS INSTALLED
CORRECTLY, CLEAN FIREBOX AREA, FILL HOPPER, PLUG UNIT BACK IN,
PRIME FEED TUBE IF NEEDED AND TURN UNIT ON.
AFTER A FEW
MINUTES, DID A
FIRE START?
REMOVE FEED
SYSTEM AND
CHECK FOR
OBSTRUCTIONS
SYSTEM IS
REPAIRED
IS THE AUGER
FEEDING
PELLETS INTO
THE FIREPOT?
YES
NO
MAKE SURE THE
HOPPER LID IS
CLOSED
DID ANY RED
ALARM CODES
FLASH AFTER
5 MINUTES OF
OPERATION?
PROCEED TO
THE IGNITER
TROUBLE
SHOOTING
SECTION
(PG#9)
MAKE THE REPAIR BY
EITHER CLEANING OR
REPLACING THE
COMPONENT.
BAD
GOOD
BAD
CHECK THE
VACUUM SWITCH
CONNECTIONS
AND VACUUM
HOSE
HOME
HOME
PAGE 5
YES
NO
IDENTIFY THE
CODE AND GO TO
THE APPLICABLE
TROUBLE SHOOT-
ING SECTION.
YES
NO
To Next Page
Loading...
