Peltor MT53H7AWS2 - Mobile Phone Ring Tone; Answering Mobile Calls; Voice-Activated Mobile Calls; Mobile Call Management

10
11
D5 Ring tone from a connected telephone
The ring tone is determined by the mobile phone. If the mobile phone
retransmits its own special ring tone, then you will hear this. Otherwise
you will hear the headset ring tone, which consists of a series of four
tones rising in frequency.
D6 Answering incoming calls using a connected mobile phone
• Briey press the PTT button (7.4) to take the call using the headset.
NOTE: For maximum noise compensation, the microphone on the
headset must be positioned 3–5 mm from your lips.
D7 Making voice-activated calls from a headset using a connected
mobile phone
This feature is provided by some mobile phones and is therefore spe-
cic to each phone.
• Briey press the PTT button (7.4) and say your voice code.
Some mobile phones do not give a prompt signal when it is time to say
your voice code.
D8 Number call back using a connected mobile phone
• Press and hold the PTT button (7.4) for more than two seconds to
reconnect the headset to the last number called.
This feature is only available on mobile phones that use the Bluetooth
hands-free prole.
D9 Switching between calls using a connected mobile phone
• Press and hold the PTT button (7.4) for more than two seconds to
switch a phone call to the handset.
This feature is only available on mobile phones that use the Bluetooth
hands-free prole.
D10 Adjusting the volume of received calls
There are ve volume settings.
• Briey press raise volume + (7.2) to increase the volume by one step.
• Briey press lower volume - (7.3) to decrease the volume by one step.
The volume can also be adjusted by holding in the relevant volume but-
ton for a longer period. A tone will indicate each step, with a lower tone
at the end of the range. It takes about four seconds to go from min. to
max. or vice versa. The volume can only be adjusted while a call is in
progress. The last setting is stored when the headset is switched off.
The headset volume can be adjusted from a mobile phone if it sup-
ports this feature. (See the user’s instructions for the telephone.)
Microphone muting only affects the sound from the headset microphone
and is only possible when the audio link is connected, Microphone mut-
ing is reset after each connection.
NOTE! Adjust the volume when you are working in a noisy environment,
since all warning signals will be controlled by the volume setting.
D11 Adjusting side tone while transmitting and during phone calls
When side tone is switched on, you will also hear your own voice in
the headset. There are ve side tone settings. The level can only be
adjusted when the audio link is connected. When this feature is
switched off, side tone will only work when the PTT button is pressed,
or if voice-activated transmission is active, or during a voice call with a
mobile phone.