PressureMAT User Guide
Revision 1
Page 9/29
1.2.2.Specifications
Control System Component Specifications
Enclosure H x W x D: 7.86” x 4.47” x 2.25”
(19.96 x 11.35 x 5.72 cm)
Approx: 1.43 lbs. (0.65 kgs)
Material: ABS Plastic
Panel/wall mount optional
NEMA 4X front panel
Environmental Temperature: 0–55° C (32–132° F)
Humidity: 0–95% RH non-condensing, Shipping/Storage:
–20° to +85° C
(warm up to rated accuracy = 6 min.)
Keypad 8 button keypad with LEXAN® overlay
Display 8 line LCD backlit blue- psi as XX.X and bar as X.XX
Power Inlet 2.5 mm Circular Power Jack (center post positive)
12-24 Volts DC
4 Watts
(powered by supplied appropriate wall supply)
Pressure Sensor Inputs Configured for PendoTECH Single Use Pressure Sensors*
(See Appendix B)
Connector on reusable cable: DB15
Excitation voltage: 4.096V +/- 0.1%
Relay Output Specifications for relay used for the alarm output:
• Normally OPEN or CLOSED via wiring
• 28 Volt AC/DC Maximum
• 1 amp closure, 2 amps maximum current
• 20 mS max turn on/off time
• Screw terminal connector
Analog Outputs (4-20 mA) Screw terminal connector
4-20mA Range: -10 to 75 psi (-0.689 bar to 5.171 bar)
Accuracy: 0.1% of full scale
Sourcing w/Maximum Load: 400 Ohms
Load Impedance: Zero Ohm minimum resistance,
20 mAmp maximum output (even if pressure exceeds 5.17
bar)
Regulatory Compliances CE Mark EN61326-1
FCC Part 15 Class B verified
FCC Part 68 5TUUSA-23969-DT-E
* See Appendix B for important information on this product
LEXAN® is a registered trademark of General Electric Company
To Next Page
Loading...
