16
OPERATION
Electrical connection
Ensure Prongs are clean
Walk around and check that lights are working properly
A good clean connection will ensure the scale gets the right voltage.
Weighing system
WEIGHING
There are various scale indicators available for use on your PENTA TMR MIXER. The
mounting assembly for all DIGI-STAR scale indicators is the same. When attaching the
indicator to the Mixer, be sure it is securely fastened. The indicator bolts onto the
mounting bracket. (Digi-Star EZ2810) check digi-star website for more options on scale
heads and software options. www.digi-star.com.
The scale indicator is mounted, on standard models, on the viewing platform of the mixer
and is able to turn to face every direction. Be certain that the indicator is fastened
securely, especially when traveling at speeds over 10 km/h (6 mph) or over uneven
surfaces. The 12 volt D.C. negative ground power supply which is needed to power
standard models can be taken from the power supply of the tractor which can be supplied
by a number of different power plugs.
For mixers using a self-contained battery, the tractor plug is to be connected directly to
the battery.
Make sure the scale head is off when charging the battery.
Be sure to conform to all safety and operational instructions and containing to the battery
to avoid injury or death.
NOTE: The scale will be programmed to display the weight in either kilograms or pounds.
This is set by the manufacturer and must be ordered to suit. If your scale is not
programmed to your preferred units of measurements, please contact your local PENTA
TMR Vertical Mixer Dealer.
To Next Page
