P
pamjonesJul 26, 2025
What to do if Pentair 75 exchanger scaled?
- DDanielle BruceJul 26, 2025
If the heat exchanger in your Pentair Swimming Pool Heater is scaled, shut off the gas supply and call a serviceman.
To Next PageTo Next PageWhat to do if Pentair 75 exchanger scaled?
If the heat exchanger in your Pentair Swimming Pool Heater is scaled, shut off the gas supply and call a serviceman.
What to do if my Pentair 75 Swimming Pool Heater will not come on?
If your Pentair Swimming Pool Heater won't turn on, several factors could be at play. First, ensure the pump is running. If not, place it in operation. Check for any leaks that may be causing the pump to be air-locked. A dirty filter or clogged pump strainer can also prevent the heater from starting, so clean them. Verify that the on-off switch is in the 'ON' position. Defective wiring or a faulty pressure switch may be the culprit, requiring you to repair or replace the wires or switch, respectively. If the automatic ignition system fails, or you suspect defective gas controls, and the electrical connections are securely fastened, it's best to call a serviceman.
Why is my Pentair 75 short cycling?
If your Pentair Swimming Pool Heater is short cycling, meaning it rapidly turns on and off, the issue might stem from insufficient water flow. Try cleaning the filter and pump strainer to improve water flow. Defective wiring could also cause this problem, so consider repairing or replacing the wiring. If the by-pass valve is defective or stuck, or the hi-limit and/or thermostat are defective, it is best to call a serviceman.
What to do if Pentair Swimming Pool Heater operating after pump has shut off?
If your Pentair Swimming Pool Heater continues to operate after the pump has shut off, shut off the gas supply and call a serviceman.
General| BTU Input | 75, 000 BTU/hr |
|---|---|
| Efficiency | 82% |
| Fuel Type | Natural Gas or Propane |
| Minimum Flow Rate | 20 GPM |
| Inlet/Outlet Size | 2" NPT |
Essential safety guidelines for users operating the pool and spa heater.
Step-by-step guide for initiating and running the direct spark ignition heater.
Essential safety guidelines for lighting the millivolt pilot system safely.
Detailed steps for manually lighting the millivolt pilot and main burner.
Overview of thermostat controls for both DSI and Millivolt heater models.
Procedure for handling ignition lockout errors and recovery.
Importance of maintaining proper disinfectant levels and pH for heater longevity.
Procedures for installing gas lines and selecting appropriate pipe sizes.
How to test and adjust the manifold gas pressure for correct operation.
Requirements and precautions for ventilating heaters installed outdoors.
Standards for vent pipe installation, termination, and combustion air supply.
Wiring schematic for the electronic direct spark ignition system.
Wiring schematic for the millivolt standing pilot ignition system.
Common causes and remedies for the heater failing to start or respond.
