Do you have a question about the Pentair MASTERTEMP 200 HD and is the answer not in the manual?
Model | MASTERTEMP 200 HD |
---|---|
Category | Swimming Pool Heater |
Heating Capacity | 200, 000 BTU/hr |
Fuel Type | Natural Gas or Propane |
Heat Exchanger Material | Cupro Nickel |
Digital Display | Yes |
Thermostat | Yes |
Minimum Flow Rate | 20 GPM |
Maximum Working Pressure | 50 PSI |
Voltage | 120V |
Ignition | Electronic |
Water Connections | 2" PVC |
Warranty | 1 Year |
Efficiency | 82% |
Outlines critical safety warnings regarding carbon monoxide, overheating, and water temperature hazards.
Details safety warnings for operating the heater, including gas leaks, fire hazards, and carbon monoxide risks.
Explains the function of the MasterTemp heater's control panel buttons, indicator lights, and temperature display.
Covers the basic steps for operating the heater, including pre-startup checks and lighting procedures.
Details the procedure for starting up and turning off the MasterTemp heater, including safety steps.
Explains the function of safety controls like the Air Flow Switch, Water Pressure Switch, and High Limits.
Describes the ignition module operation and how to set pool and spa temperatures.
Guides users through initial troubleshooting steps before consulting specific charts.
Troubleshooting chart for diagnosing why the heater will not fire (Part A).
Troubleshooting chart for diagnosing why the heater will not fire (Part B).
Troubleshooting chart for diagnosing why the heater will not fire (Part C).
Troubleshooting chart for diagnosing why the heater will not fire (Part D).
Interprets diagnostic LED indicators (AGS, AFS, HLS, PS, THERMISTOR) for troubleshooting.
Addresses common symptoms and causes for burner and heat exchanger problems.