OK
OK
1.1 - Grab robotic cleaner by the front handle and place it vertically,
sitting on its rear bumpers on a flat surface .
1.2 - Insert your hands in each side of the filter canister and simul-
taneously press both tabs to release the canister. Pull the Canister
out and place it on a flat surface.
1.3 - Install the adequate filter in the canister.
1.4.1 - Place your fingers as indicated not higher than the
3rd rib to prevent risk of pinching.
1.4.4 - Make sure the cannister is properly installed,
it shouldn't be visible from the side view. Otherwise
repeat operations ensuring the canister is pushed to
the end before releasing the tabs.
1.4.2 - Arrows on
the cleaner and
on the canister
should match.
1.4.3 - Reposition the filter
canister by pressing simul-
taneously both tabs while
pushing the canister inside in
the robotic cleaner until the
stop, and then release the tabs
to lock it in place.
Before first use 1/3
Before the first use of the robotic cleaner, install the adequate filter in the filter canister. Two different filters are
provided:
Standard filtration (40µm): Fabric texture, recom-
mended on very dirty pools with debris such as soil,
algae, sand etc.
Thin filtration (25µm): « paper » texture, recommended
for regular cleaning and when there is only little debris.
!!! This type of filter is a consumable, do not dry in the
sun !!!
To Next Page
Loading...
