Pentair BLUESTORM - Selecting Working Modes; Operational Mode Selection

=ON
1h30
4h00
=OFF
+
=ON
( )
10s
<5s
+
=ON
( )
15s
<5s
+
=OFF
( )
15s
<5s
+
=ON
=OFF
( )
+
6s
6s
<5s
<5s
>9s
=OFF
A simple press when the cleaner is OFF will start a 1h30
automatic cleaning cycle. The green LED above “A” icon
turns ON.
A simple press when the cleaner is ON will turn it OFF
after 5 sec.
A simple press when the cleaner is
ON will turn it OFF after 5 sec. This
mode disables automatically when
the cleaner turns off.
When the cleaner is OFF, press once on the power
button then within 5 sec, press again and maintain
for 15 sec until the LED at the right of the warning
icon turns OFF.
Plug the controller on an external timer and program
operating schedule. Press once on the power button
then within 5 sec press again and maintain for 6 sec until
le LED above the timer icon turns ON.
Unplug the controller from the external timer, wait more
than 9 sec to reset memory then plug the controller direc-
tly on the power socket, then within 5 sec press the power
button and maintain for 6 sec until the LED above the
timer icon turns OFF and the green LED above “A” turns
ON. The cleaner is now in AUTO mode.
This mode ensures a water flow in the pool when main filtration is off (i.e.
winterization), the cleaner changes position every 15 min during 4 hours.
Press once on the power button then within 5 sec press again and maintain for
10 sec until le LED above the filter icon turns ON.
This mode is meant for tiles pools or when the floor is covered
with algae to optimize pool coverage, prevent over-rotations
(>180°C) and cable kinks. Press once on the power button then
within 5 sec press again and maintain for 15 sec until the LED
at the right of the warning icon turns ON. Then use the cleaner
normally in Auto or Timer mode.
Before first use 2/3
Select working mode.
AUTO MODE :
TIMER MODE :
FILTRATION ASSIST MODE :
SLIPPERY FLOOR MODE :