OK
INT EXT
Before first use 3/3
If the pool floor has transitions or if the main drain is too high, it is recommended to install the 4 wheels on the filter
canister to prevent the cleaner to get stuck.
2.1 – Install the 4 wheels provided in the accessories bag on the filter canister according the below
instructions. Screw (cross tip) from the outside in, nut inside (12 mm closed-end wrench). Tight
reasonably to prevent damaging the canister.
2.2 – Install the canister box following steps 1.4 then verify that the wheels are a couple of millime-
ters above the floor.
To Next Page
Loading...
