7
OK
OK
4.6 - If necessary (i.e. if fine debris pass through the
filter), clean the inside of the robotic cleaner with a
hose to remove dirt from the impeller and turret.
4.7 - Install the adequate filter in the canister.
4.8.1 - Place your fingers as indicated not higher than the
3rd rib to prevent risk of pinching.
4.8.4 - Make sure the cannister is properly
installed, it shouldn't be visible from the
side view. Otherwise repeat operations
ensuring the canister is pushed to the end
before releasing the tabs.
4.8.2 - Arrows on
the cleaner and
on the canister
should match.
4.8.3 - Reposition the filter
canister by pressing simul-
taneously both tabs while
pushing the canister inside
in the robotic cleaner until
the stop, and then release
the tabs to lock it in place.
Cleaning of the robot cleaner 2/2
To Next Page
Loading...
