vi
Note: Refer to page 3 where (parts index number) is shown
EasyTouch/IntelliTouch Control System Upgrade Kits Installation Guide
Qualifications for Installers and Users
This product must be installed by a qualified pool technician in accordance with all applicable
local codes and ordinances. It must be serviced by someone who fully understands its operation.
Improper installation or servicing could result in death or serious injury to pool users, installers,
servicers, or others and may also cause damage to property.
If you are not familiar with your pool filtering system and/or heater, do NOT attempt to adjust or
service without consulting your dealer or a qualified pool technician.
Do not permit children to use this product.
Pentair Water Pool and Spa
IMPORTANT SAFETY INSTRUCTIONS
For Installation of Electrical Controls at Equipment Pad
(ON/OFF Switches, Timers, and Automation Control Systems)
Install all electrical controls at equipment pad, such as on/off switches, timers,
and control systems, etc. to allow the operation (start-up, shut-down, or
servicing) of any pump or filter so the user does not place any portion of his/
her body over or near the pump strainer lid, filter lid or valve closures. This
installation should allow the user enough space to stand clear of the filter and
pump during system start-up, shut down or servicing of the system filter.
HAZARDOUS PRESSURE: STAND CLEAR OF PUMP AND FILTER
DURING START-UP
CAUTION! INSTALL POWER CENTER TO ALLOW USER ENOUGH SPACE TO
STAND CLEAR OF PUMP AND FILTER WHEN SERVICING.
To Next Page
Loading...
Need help?
General
