INTELLICHLOR
®
Salt Chlorinator Installation Guide
i
Most states and local codes regulate the construction, installation, and
operation of public pools and spas, and the construction of residential
pools and spas. It is important to comply with these codes, many of which directly
regulate the installation and use of this product. Consult your local building and health
codes for more information. Before attempting installation of service, ensure that all
power to the circuit supplying power to the IntelliChlor Salt Chlorine Power Center(s)
is disconnected/switched off at the circuit breaker.
SERIOUS BODILY INJURY OR DEATH CAN RESULT IF THIS
PRODUCT IS NOT INSTALLED AND USED CORRECTLY.
INSTALLERS AND POOL OPERATORS MUST READ THESE
WARNINGS AND ALL INSTRUCTIONS BEFORE USING THIS
PUMP AND SAND FILTER. To reduce the risk of injury, service
should only be done by a qualified pool service professional.
Before installing this product, read and follow all warning notices
and instructions in this Guide. Failure to follow warnings and
instructions can result in severe injury, death, or property damage.
Call (800) 831-7133 for additional free copies of these instructions. Please refer to
www.pentaircommercial.com for more information related to these products.
IMPORTANT NOTICE - Attention Installer: This Installation and User’s
Guide (“Guide”) contains important information about the installation,
operation and safe use of this product. This Guide should be given to the
owner and/or operator of this equipment.
IMPORTANT WARNINGS AND SAFETY INSTRUCTIONS
IMPORTANT SAFETY INSTRUCTIONS PERTAINING TO A RISK OF
FIRE, ELECTRIC SHOCK, OR INJURY TO PERSONS. READ AND
FOLLOW ALL INSTRUCTIONS.
CHLORINE GAS BUILDUP CAN OCCUR WITH IMPROPER WIRING:
To reduce the risk of personal injury the IntelliChlor
®
Salt Chlorinator
Power Center must be installed on and wired to the load side of the
time clock, electronically controlled switch, or relay load side, so that it
will receive power only when the pool pump is on. Otherwise,
dangerous chlorine gas buildup can occur. The IntelliChlor Salt
Chlorinator should never be energized when the pool pump is OFF
and water is not flowing through the unit.
To reduce the risk of injury, do not permit children to use or operate this
pump and sand filter.
When setting up pool water turnovers or flow rates the operator must
consider local codes governing turnover as well as disinfectant feed
ratios.
DO NOT increase pump size; this may increase the flow rate through the
system and exceed the maximum flow rate stated on the drain cover.
Never operate the IntelliChlor Salt Chlorinator without proper flow or
water circulation. A build-up of flammable gases will result in
hazardous conditions.
Operate unit with minimum flow of 25 gpm. For high flow
applications, use a bypass loop.
To Next Page
Loading...
Need help?
General
