Pentair IntelliFlo VS-3050 - Page 22

14
IntelliFlo VS-3050 Installation and User’s Guide
6. Strip back the cable conductors ¼”. Insert the wires into the either of the COM PORTS
(J7 andJ8) screw terminals located on the left side of the Personality board. Secure the wires with
the screws. For wiring details, refer to ”Pin Configuration” shown below. Note: Multiple wires may
be inserted into a single screw terminal. Strip back the cable conductors ¼ inch. Insert the two
wires into the screw terminals on the board. Secure the wires with the screws.
.
Pin Configuration IntelliFlo to IntelliTouch pin configuration:
• IntelliFlo: Connect pin 6 (green) to IntelliTouch screw terminal pin 2 (green)
• IntelliFlo: Connect pin 7 (yellow) to IntelliTouch screw terminal pin 3 (yellow)
7. Close the control panel into its original position and secure it with the two access screws.
8. Install the high voltage cover panel and secure it with the two retaining screws.
9. Close the load center front door. Fasten the two spring latches.
10. Switch the power on to the load center.
BLK
GRN
YEL
RED
Pin configuration
IntelliTouch COM port (J7/J8)
screw terminal
hcuoTilletnI
lanimretwercs
rotcennoc
olFilletnI
)elbaceriw-2(
)NRG(2)6niP(NEERG
)LEY(3)7niP(OLLEY
Pin 6
(Green)
Pin 7 (Yellow)
IntelliFlo connector pin configuration
IntelliTouch Personality
board COM PORT
(J7/J8)