LEGEND
®
INSTALLATION MANUAL
D. Installing the Twist Lock Pressure Relief Valve (Wall Fitting)
1. Take out any existing pool cleaner and/or wall
fitting.
2. Turn on the filtration pump and booster pump,
flush out the plumbing line.
3. Turn off filter pump and booster pump.
4. Remove the Wall Adapter from the Wall Fitting
and screw Adapter by hand into the dedicated
line. Turn until tight.
5. Take the Wall Fitting and Twist Lock the Wall
Fitting into the Wall Adapter 1/4 turn and pull
out; to a snug fit. Once the Wall Adapter is secure,
you can now twist lock and unlock to remove
Wall Fitting with ease from the Wall Adapter.
E. Cutting the Feed Hose (See Hose Diagrams on Page 10)
The Hose assembly comes in 5 sections now covering approximately 30 ft. (9 m) of the pool, which
provides ample hose for most residential pools. The Back-Up Valve is now 30" (75 cm) from the head
cleaner and should always remain this distance. For larger pools, see #14 on Page 12 for instructions on
Adding Additional Feeder Hose
.
1. Take Feeder Hose out of box (it will be approximately 30 feet [9 meters] long). Before installing the
unit, you should lay the feed hose out straight in the sun, (for one day if possible). The hose has
been curled up in the box and sometimes will go around in a circle. If this happens, take the first or
second section of hose from the wall and reverse it, (turn it around). You might have to reverse both
sections to correct the problem. Make sure the feed hose is cut and installed properly.
2. Measure how deep your pool is by using
your telepole or the clear end of the
feeder hose. Cut the soft hose equal to
the depth of your pool. (Hint: the grate
or domed main drain at the bottom is
usually the deepest point.)
Example:
The soft hose is 10 ft. (3 m)
long, if the pool is 8½ ft. (2,5 m) deep,
cut 1½ ft. (0,5 m) off of the soft hose. If
the depth is greater than 10 ft. (3 m), do
not cut the soft hose.
Deepest End of Pool
Telepole / Soft Hose
Measure and Mark the Water Level
Main Drain
WALL ADAPTER
INSTALLED
QUICK
LOCK
PEG
QUICK DISCONNECT
O-RING
[English] 9
To Next Page
Loading...
