EasyManuals Logo

Pentair MASTERTEMP Instructions

Pentair MASTERTEMP
2 pages
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #2 background imageLoading...
Page #2 background image
P/N 473756 Rev. A 1-21-08
Location
The 2-inch Pipe Plug, (for access to Internal Bypass
Valve), is located at the top of the Manifold.
Function
The 2-inch Pipe Plug provides access to the Internal
Bypass Valve.
Servicing Procedure
To remove the Bypass Access Plug:
WARNING
Fire or explosion hazard. Disconnect all power
to the heater and close the External Manual
Gas Valve before starting this procedure.
1. Turn off the filter pump and all electrical
power to the heater. Close the external Manual
Gas Valve.
2. If the heater is below the water level of the
pool, close isolation valves to avoid draining
the pool.
3. Open the Pressure Relief Valve to drain the
heater.
4. Remove covers or doors and panels for access
to the Bypass Access Plug.
5. Insert the Pipe Plug Tool into the Manifold
Bypass Access Plug, see Figure 2.
6. Using a 7/8” open end wrench, or an
adjustable wrench, turn the Pipe Plug Tool
counter-clockwise to open the Bypass Access
Plug. You will now have access to the Internal
Bypass Valve.
7. Reassemble the Manifold Bypass Access Plug
by reversing Steps 1 through 6 above.
[NOTE: A.S.M.E. manifolds must not be removed
from heater units since it would void the A.S.M.E.
certification.]
7/8" Open End Wrench
Tool, Pipe Plug
Bypass Access Plug
[Manifold]
Manifold
[A.S.M.E.]
Figure 2.
Save These Instructions Together With Your Existing Operation & Installation Manual For Future Reference.
© 2008 Pentair Water Pool and Spa, Inc. All rights reserved.
This document is subject to change without notice.
Trademarks and Disclaimers: The
Pentair Pool Products
®
logo
,
Because reliability matters most
®
,
MasterTemp
®
and Max-E-Therm
®
are trademarks and/or registered trademarks of
Pentair Water Pool and Spa, Inc. and/or its affiliated companies in the United States and/or other counties. Sta-Rite
®
is a trademark and/or registered trademark of Sta-Rite Industries, LLC.
Unless noted, names and brands of others that may be used in this document are not used to indicate an affiliation or endorsement between the proprietors of these names and brands
and Pentair Water Pool and Spa, Inc. Those names and brands may be the trademarks or registered trademarks of those parties or others.
Manifold
[A.S.M.E.]
Figure 1.

Other manuals for Pentair MASTERTEMP

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Pentair MASTERTEMP and is the answer not in the manual?

Pentair MASTERTEMP Specifications

General IconGeneral
ModelMASTERTEMP
CategorySwimming Pool Heater
BrandPentair
BTU Ratings125, 000 - 400, 000 BTU/hr
Fuel TypeNatural Gas or Propane
DisplayDigital display
Water Flow Rate20-120 GPM
Efficiency82% (Thermal Efficiency)
IgnitionElectronic
Voltage120V or 240V
Operating Pressure50 PSI (Maximum)
Temperature Range104°F
DimensionsVaries by model
WeightVaries by model
WarrantyLimited Warranty

Related product manuals