Pentair PG2000 User Manual

Rev. C 5-15-09 1 P/N 840263
PG2000
®
Owner's Manual
Pentair Water Pool and Spa, Inc.
1620 Hawkins Ave., Sanford, NC 27330 • (800) 831-7133 • (919) 566-8000
10951 West Los Angeles Ave., Moorpark, CA 93021 • (800) 831-7133 • (805) 553-5000
Visit us on the Internet at: www.pentairpool.com or www.staritepool.com
Specifications:
Electrical: 120 VAC 60 Hz
Operating load: 2 amps
Material: High Strength Plastic
Weight: 20 lbs.
Lamp: 150 Watt Metal-Halide
Lamp Life: 6000 hours
Restrike time: 2-3 minutes

Pentair PG2000 Specifications

General

Model	PG2000
Manufacturer	Pentair
Category	Lighting Equipment
Voltage	12V
Cord Length	50 ft
Light Source	Incandescent
Installation	Wet Niche
Underwater Light	Yes
Type	Underwater Light

Summary

Product Specifications

Important Safety Instructions

Operating the PG2000

Instructions for operating the PG2000 unit, including switch positions and ventilation requirements.

Replacing the Bulb

Step-by-step guide for safely replacing the bulb, including warnings about heat and electrical shock.

Synchronization Procedures

Synchronization Start Conditions

Conditions required before starting the synchronization process between SAm® and PG2000®.

Synchronization Procedure

Steps to synchronize the PG2000® colorwheel with SAm® light for synchronized fiber optics.

Visual Synchronization Method

Alternative method for synchronizing PG2000® with SAm® using visual cues.

Troubleshooting

Unit Not Coming On

Resolving issues where the PG2000® illuminator does not power on or light up.

No Light Output

Diagnosing and fixing problems when there is no light despite the unit being on.

Light Cycles On and Off

Addressing intermittent light output caused by overheating or ventilation issues.

Fan Not Running

Immediate actions to take if the PG2000® fan is not operating to prevent damage.

Colors Not Changing

Troubleshooting steps for when the colorwheel fails to change colors.