Pentair PROWLER 930W - Page 12

8
PROWLER® 930W Robotic Inground Pool Cleaner Installation and Maintenance Guide
Cleaning the Impeller
Always disconnect power to the cleaner before servicing, disassembly, or reassembly. Failure to do so could result
in death or serious injury to servicemen, pool users or others due to electrical shock. Read all servicing instructions
before servicing the cleaner.
Every so often debris may become trapped in the cleaner’s impeller. To remove debris trapped in the
impeller follow the instructions below:
STEP 1:
Open the Filter Cover and Remove the
Basket
See Figure 27 and Figure 28.
FIGURE 27 FIGURE 28
STEP 2:
Unmount and Remove the Intermediate Cover and Manifold
Assembly
1. Using a No. 2 Phillips-head screwdriver, remove the two
screws that hold the intermediate cover and manifold
assembly in place. These screws can be found in the inside
corners of the intermediate cover. See Figure 29.
2. Place the two screws aside.
3. Gently pull the intermediate cover (Item #2 in Figure 29)
away from the cleaner and place it aside.
4. Gently pull the manifold assembly (Item #3 in Figure 29)
away from the cleaner and place it aside.
2
1
3
FIGURE 29
STEP 3:
Unmount and Remove the Impeller Cover
Press the tabs on both sides of the impeller cover
(Item #1 in Figure 30) to unlock the cover from
the impeller assembly. While pressing both tabs,
pull the cover away from the cleaner.
Place the impeller cover aside.
1
FIGURE 30