PROWLER® 930W Robotic Inground Pool Cleaner Installation and Maintenance Guide
9
Storing the Cleaner
If the cleaner will not be used for an extended period of time, follow the storage recommendations
below:
• Be sure to disconnect the power supply after use.
• Store the power supply, cable and cleaner on the caddy.
• Store the cleaner in a protected area out of direct sun, rain and frost, at a temperature between
41°-113°F (5°-45°C).
• Drain all water from the pool cleaner.
• Thoroughly clean the filter baskets and filter screens and store the cleaner with them installed.
STEP 5:
Remount the Impeller Cover
Gently push the impeller cover back onto the
impeller assembly. See Figure 32.
The tabs on the motor unit will lock the cover into
place.
FIGURE 32
STEP 6:
Remount the Intermediate Cover and
Manifold Assembly
Reseat the manifold assembly and intermediate
cover. Reinstall the two screws. See Figure 33.
FIGURE 33
FIGURE 31
STEP 4:
Clean Debris from the Impeller
By hand, remove any debris that has become
trapped inside the impeller. See Figure 31.
To Next Page
Loading...
