Pentair PROWLER 930W - Operating Your Prowler Pool Cleaner; Prowler Dashboard Navigation

4
PROWLER® 930W Robotic Inground Pool Cleaner Installation and Maintenance Guide
STEP 5:
Install the Handle
1. Insert the handle
into the handle
support. See
Figure 11.
2. Push the handle
into the support
as far as possible.
FIGURE 11
STEP 6:
Install the Power Supply Clip
1. Using the two longer Phillips-head screws,
two washers and two 5/16” (8 mm) nuts
provided with the caddy, install the power
supply hook onto the handle support. See
Figure 12.
5/16”
(8mm)
FIGURE 12
STEP 7:
Install the Power Cable Holder
1. Using the final two shorter Phillips-head
screws, secure the power cable holder to the
caddy handle. See Figure 13.
FIGURE 13
STEP 8:
Attach the Power Supply to the Caddy
1. Hook the power supply’s handle over the top lip
of the power supply clip. See Figure 14 (A).
2. Tilt the power supply toward the handle support
until the power supply snaps into the bottom lip
of the power supply clip. See Figure 14 (B).
A
B
FIGURE 14