15
RACER
™
Pressure Side Pool Cleaner Installation and User’s Guide
RACER
™
Pressure Side Pool Cleaner Installation and User’s Guide
Problem Corrective Action
Brush on front of cleaner is not spinning.
Watch front wheels while cleaner is operating in the pool. The wheels and front
brush should rotate simultaneously.
Ensure the scrubber is free of tangled debris.
Rear wheels dragging/not spinning.
Ensure the wheel sleeve is free of tangled debris.
Note: You may need to remove the wheel by pulling straight off sleeve to
remove any tangled debris.
Rear wheels falling off.
Replace wheel and wheel sleeve.
Night Cruize™ LEDs are not illuminated
during cleaner operation. (Note: LED
operation does not affect cleaner
performance.)
Debris may be clogging generator turbine. To clean debris from generator turbine:
Find access hole under the left rear wheel by removing the wheel by pulling it
straight off cleaner. Use a large paper clip and insert approximately 2in. straight into
the access hole, continue until the generator turbine paddle is felt and move paper
clip until paddle rotates. Rotate the paddle several times with paper clip to clear the
debris.
TROUBLESHOOTING (Continued)
Insert paper clip in
access hole.
ESPAÑOL 20
FRANÇAIS 43
ENGLISH
To Next Page
Loading...
