Pentax A3000 - Page 14

4. As illustrated,
pullthe
film leader
out so that
its
end aligns with the
O
fitm
leader
end
mark
(red
bar); in other words,
bring
the
film leader
end
within
the length
of the
bar.
o
Make
sure
that
the
perforations
on the bottom
side of the film
have engaged
the
€)
sprocket
teeth as well
as the
O spool teeth.
o
Also
make
sure that the f ilm is
properly placed
between the two
€)
guide
rails.
o
Take
up any
slack
left in
the film
so that the
f
ilm
is flat
as shown, by rewinding
it
slightly
into
the
cartridge.
o
When
a
film with
a
higher
ISO number
is
loaded,
do not leave
the
camera out of the case
for
a
long
time.
www.orphancameras.com