Pentax IQZoom 135 M - Statement of FCC Compliance; FCC Regulatory Compliance

In any case, however, shipping charges and
customs clearance fees are to be borne by the
sender. To prove the date of your purchase
when required, please keep the receipts or bills
covering the purchase of your equipment for at
least a year. Before sending your equipment for
servicing, please make sure that you are send¬
ing it to the manufacture’s authorized represen¬
tatives or their approved repair shops, unless
you are sending it directly to the manufacturer.
Always obtain a quotation for the service
charge, and only after you accept the quoted
service charge, instruct the service station to
proceed with the servicing.
This warranty does not apply to Pentax prod¬
ucts purchased in the United States.
Therefore, for warranty Information regard¬
ing Pentax products purchased in the United
States, please read the warranty card sup¬
plied with your product.
The CE mark is Directive conformity mark
of the European Community (EC).
STATEMENT OF FCC COMPLIANCE
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference,
and (2) this device must accept any interference
received, including interference that may cause
undesired operation.
Changes or modifications not approved by the par^
responsible for compliance could void the user’s
authority to operate the equipment.
This equipment has been tested and found to com¬
ply with the limits for a Class B digital device, pur¬
suant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against
harmful interference in a residential Installation. This
equipment generates, uses and can radiate fre¬
quency energy and, if not installed and used in
accordance with the Instructions, may cause harm¬
ful interference to radio communications. However,
there is no guarantee that Interference will not occur
in a particular installation. If this equipment does
cause harmful interference to radio or television
reception, which can be determined by turning the
equipment off and on, the user is encourage to try to
correct the interference by one or more of the fol¬
lowing measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment
and receiver. u
• Consult the dealer or an experience radio/TV tech¬
nician for help.