105
Shooting Functions
4
6
Point the remote control unit
towards the remote control
receiver on the front of the
camera, and press the shutter
release button on the remote
control unit.
The maximum operating distance of the
remote control unit is about 4 m from the front of the camera.
After a picture is taken, the remote control receiver lights for 2 seconds
and then returns to blinking.
• By default, you cannot adjust the focus with the remote control unit. Focus on
the subject first with the camera before operating with the remote control unit.
When [11. AF with Remote Control] (p.72) is set to [On] in the [A Custom
Setting 2] menu, you can use the remote control unit to adjust the focus.
• Select 9 (Single Frame Shooting) in the Drive Mode setting screen to cancel
shooting with a remote control unit. The setting is canceled automatically
when the camera is turned off if [Drive Mode] is set to P (Off) in [Memory] of
the [A Rec. Mode 3] menu. (p.195)
• The Shake Reduction function is fixed to R (Off).
• Shooting with a remote control unit may not be available in backlit conditions.
• When using the Remote Control Waterproof O-RC1, the autofocus system
can be operated with the S button. The { button cannot be used.
• The Remote Control F can send a remote control signal about 30,000 times.
Contact a PENTAX Service Center to replace the battery (this will involve a
fee).
4 m
To Next Page
Loading...
Need help?
General
Weight and Dimensions
