To Next PageTo Next Page
Need help?Do you have a question about the Pentax R-422VN and is the answer not in the manual?
General| Brand | Pentax |
|---|---|
| Model | R-422VN |
| Category | Measuring Instruments |
| Language | English |
Explains the function of each key on the device's control panel.
Details the functionality assigned to F1-F5 keys for various operations.
Describes MODE A/B display combinations and alphanumeric input methods.
Overview of the PowerTopoLite software and its features.
Guidance on how to effectively use the PowerTopoLite manual.
Step-by-step guide to launch the PowerTopoLite software.
Describes the allocation of function keys for PowerTopoLite operations.
Lists and explains common function keys used in the software.
Covers memory status, job creation, selection, and deletion.
How to clear all job files from the instrument.
Covers setting up station using Rectangular and Polar coordinates.
Procedures for orienting the station for accurate measurements.
Explains MEASURE screen, Remote, Offset, H. Angle, IH measurement.
Displays recorded points graphically for review and analysis.
Creating, editing data, and managing point codes.
Methods for free stationing using multiple or two known points.
Step-by-step guide for staking out points in the field.
Staking out points relative to defined lines and arcs.
Overview of Coordinate Geometry (COGO) functions including Inverse, offsets, intersections.
Calculates 2D surface area and 3D surface/volume of polygons.
Calculates height using Remote Elevation Measurement technique.
Using Virtual Plane Measurement for point coordinate acquisition.
PH input, reference to target distance, target to target distance.
Procedure for changing the reference point for measurements.
Explains fixed, closed, and open traverse measurement methods.
Start point, corner point measuring, and calculation procedures.
Writing and reading data using text files (CSV, DC1, ExtCSV).
Transferring data between the instrument and PC via USB.
Transferring data via COM port using RS-232C.
Configuring communication parameters for data transfer.
Language, coordinate system, and input method settings.
Remote, compare, EDM, aiming, and measurement display settings.
Elevation factor, duplicate point check, and save mode settings.
Enabling measurements with both telescope faces.
