Pentax Zoom 280-P User Manual

7,
UNLOADING
cii ^ camera in the shade or use your body
rlLm to shade the camera.)
Rewinding the film
After you have exposed the last frame of the roll, the
lens retracts and the film rewinds automatically.
Then, the motor stops, and (0 Of ) blinks as shown
to indicate that the film has been rewound. To un¬
load the film, open the back cover. Remove the car¬
tridge by pulling the top first.
• A 24-exposure roll of film takes about 20 seconds
to be rewound.
• During rewinding, the exposure counter counts
frame numbers in reverse.
• The entire roll of film including the film leader is
always rewound into the cartridge to prevent any
part of the film being exposed to light.
14
Rewinding a film in mid-roll
If you wish to unload a film before exposing all the
frames, push the auxiliary rewind button with the
clamp’s protrusion. The lens retracts automatically
and film rewinding starts.
Notes:
• The shutter may be released a frame or two even
after the specified number of frames have been
used up as indicated by the number of shots
shown on the film canister. If this occurs, these
frames may not be developed.
• Never open the back cover until the whole film
roll is rewound.

Pentax Zoom 280-P Specifications

General

Brand	Pentax
Model	Zoom 280-P
Category	Digital Camera
Language	English