Pentax Zoom 280-P - Page 41

Zooming using the Remote Control
When the Remote Control Projector is aimed
towards the camera's Remote Control Re¬
ceiver, each time you depress the zooming
button located on the Remote Control, the
lens zooms and stops at steps of 80, 50, and
28mm focal length settings continuously.
* When using the Remote Control to zoom
the lens, frame the subject through the
viewfinder, assuming the setting of the
zoom lens is 80mm telephoto setting. Oth¬
erwise, the subject will be out of the picture
area.
* You may zoom the lens in and out to
change the picture area with the Remote
Control while the focus is being locked.
Attaching the Remote Control
Attach the Remote Control to the camera af¬
ter use. Slide the Remote Control until it locks
in place with a click.
Battery life on the Remote Control
About 30,000 commands can be issued using
the Remote Control with a battery installed.
Have exhausted battery replaced at your local
Pentax Service center if the battery is ex¬
hausted (service is chargeable).
37