Pentax Zoom 280-P - Page 43

Correcting the date
1. Depress the Select button @ to make a dif¬
ferent category of digits on the LCD panel
you want to change blink.
2. Depress the Adjust button 0 to change
digits of the specified category you chose
with the Select button 0. Digits increase
by one each time you depress the Adjust
button 0. Holding down the button will
advance digits continuously.
* The blinking allows precise fine-tuning
of the internal clock to the beginning of a
specified minute. To do so, depress the
Select button 0 to make the blink, and
then depress the Adjust button 0 in sync
with a time signal.
3. After the data has been adjusted, depress
the Select button. The bar mark (-) appears
on the LCD panel, indicating that data im¬
printing choices are possible.
* If you release the shutter while the blinking
data is being corrected, the data cannot be
imprinted.
* Numerical indication
Year= 87-19 (1987-2019)
Month= 1-12
Day= 1-31
Time= 0-23
Minute= 00-59
OPERATIONAL PRECAUTIONS
The data on the LCD panel is imprinted on
each frame you expose.
* "Year-Month-Day" and "Day-Hour-Min¬
ute" cannot be Imprinted at the same time.
* As you release the shutter, the bar (-) mark
on the display blinks for a few seconds,
indicating the data has been imprinted,
* If there is a white or yellow object in the
corner of the picture where the data is im¬
printed, the data may be difficult to read.
When composing your photographs, try to
avoid brightly-colored subjects in that cor¬
ner.
* The date and time will not appear on the
panoramic format pictures.
39