configured LAN IP address.
ā At a subsequent point when the master Pepwave router recovers, it will once again
become active.
You can configure high availability at Advanced > Misc. Settings > High Availability.
Interface for Master Router
Interface for Slave Router
Checking this box specifies that the Pepwave router is part of a high availability
configuration.
This number identifies a pair of Pepwave routers operating in a high availability
configuration. The two Pepwave routers in the pair must have the same Group
Number value.
This setting specifies whether the Pepwave router operates in master or slave
mode. Click the corresponding radio button to set the role of the unit. One of the
units in the pair must be configured as the master, and the other unit must be
configured as the slave.
Resume Master
Role Upon
Recovery
This option is displayed when Master mode is selected in Preferred Role. If this
option is enabled, once the device has recovered from an outage, it will take over
and resume its Master role from the slave unit.
This option is displayed when Slave mode is selected in Preferred Role. If this
option is enabled and the Master Serial Number entered matches with the actual
master unit's, the master unit will automatically transfer the configuration to this unit.
Please make sure the LAN IP Address and the Subnet Mask fields are set
correctly in the LAN settings page. You can refer to the Event Log for the
configuration synchronization status.
If Configuration Sync. is checked, the serial number of the master unit is required
here for the feature to work properly.
The HA pair must share the same Virtual IP. The Virtual IP and the LAN
To Next Page
Loading...
Need help?
General
