This option allows you to select which 802.11 RF channel will be used. Channel
1 (2.412 GHz) is selected by default.
Auto (20/40 MHz) and 20 MHz are available. The default setting is Auto (20/40
MHz), which allows both widths to be used simultaneously.
This option is for specifying the transmission output power for the Wi-Fi AP.
There are 4 relative power levels available – Max, High, Mid, and Low. The
actual output power will be bound by the regulatory limits of the selected
country.
This option is for setting the transmit bit rate for sending a beacon. By default,
1Mbps is selected.
This option is for setting the time interval between each beacon. By default,
100ms is selected.
This field allows you to set the frequency for the beacon to include a delivery
traffic indication message. The interval is measured in milliseconds. The default
value is set to 1 ms.
This field is for specifying the wait time before the Router transmits a packet. By
default, this field is set to 9 µs.
This field is for setting the wait time to receive an acknowledgement packet
before performing a retransmission. By default, this field is set to 48 µs.
This option allows you to enable frame aggregation to increase transmission
throughput.
This setting allows choosing a short or long guard period interval for your
transmissions.
To Next Page
Loading...
