This is an option to enable client load balancing for AP Controller. When the option is enabled, it
is trying to balance the station count on APs within the same profile.
Some Pepwave models displays a screen similar to the one shown below, navigating to AP >
Settings:
This option sets the country whose regulations the Pepwave router follows.
Wi-Fi Antenna Choose from the router's internal or optional external antennas, if
so equipped.
This option allows you to specify whether 802.11b and/or 802.11g client
association requests will be accepted. Available options are 802.11ng and
802.11na. By default, 802.11ng is selected.
To Next Page
Loading...
