Appendix A: Restoration of Factor y Defaults
To restore the factory default settings on a Pepwave router, follow the steps below:
1. Locate the reset button on the front or back panel of the Pepwave router.
2. With a paperclip, press and keep the reset button pressed.
Hold for approximately 20 seconds for factory reset (Note: The LED status light shows in RED,
all WAN/LAN port lights start blinking, and release the button)
After the Pepwave router finishes rebooting, the factory default settings will be restored.
All previous configurations and bandwidth usage data will be lost after restoring factory
default settings. Regular backup of configuration settings is strongly recommended.
To Next Page
Loading...
