peplink B One Series - Page 224

TCP 80
HTTP traffic
Web Admin
Interface access
Inbound
Enabled
TCP 443
HTTPS traffic
Web Admin
Interface access
(secure)
Inbound
Enabled
TCP 8822
SSH
SSH
Inbound
Disabled
UDP 161
SNMP Get
SNMP monitoring
Inbound
Disabled
UDP 162
SNMP Trap
SNMP monitoring
Outbound
Disabled
TCP, UDP 1812
Radius Authentication
Radius
Outbound
Disabled
TCP, UDP 1813
Radius Accounting
Radius
Outbound
Disabled
UDP 123
Network Time Protocol
NTP
Inbound
Outbound
Disabled
Enabled
TCP 60660
Real-time location data in
NMEA format
GPS
Outbound
Disabled
Disclaimer:
● By default, only TCP 32015 and UDP 4500 are needed for SpeedFusion VPN / SpeedFusion.
● Inbound / Outbound* - Inbound = For Server mode; Outbound = For Client mode
● UDP 32015º - If IPsec VPN or L2TP/IPsec RUA is enabled, the UDP 4500 is occupied, so
SpeedFusion VPN / SpeedFusion will automatically switch to UPD 32015 as VPN data port .
● UDP 32015+N-1^ / TCP/UDP 4500+N-1^ - When using Sub-Tunnels, multiple ports are in use (1
for each Sub-Tunnel profile).
● The default UDP data ports used when using (N number of Sub-Tunnel profiles) are:
4500…4500+N-1, or (when port 4500 is in use by IPsec or L2TP/IPsec) 32015… 32015+N-1".
https://www.peplink.com
224
Copyright @ 2024 Peplink