What to do if Pepperl+Fuchs R1000 device shows no reflector detected?
If your Pepperl+Fuchs Accessories device isn't detecting a reflector, it's likely due to a misalignment or a dirty lens. First, check the alignment of the device to ensure it's properly aimed at the reflector. If the alignment is correct, inspect the lens for any dirt or obstructions and clean it if necessary.
Why Pepperl+Fuchs R1000 Accessories gives invalid measured values?
If your Pepperl+Fuchs Accessories device is showing invalid measured values, it could be due to dirt on the device. Inspect the device for any dirt and clean the optical interface if necessary.
What to do if Pepperl+Fuchs Accessories device temperature is too high?
If your Pepperl+Fuchs Accessories device indicates the temperature is too high, this is likely because the ambient temperature is too high. To resolve this: * Ensure the device is used only within its permitted temperature range. * Check if the device is in direct sunlight. Refer to the datasheet for detailed temperature specifications.
Why Pepperl+Fuchs R1000 Accessories device temperature is too low?
If your Pepperl+Fuchs Accessories device indicates the temperature is too low, it's probably because the ambient temperature is too low. Make sure to use the device only within the permitted temperature range. If needed, wait for the temperature to rise before using the device. Refer to the datasheet for more information.
How to fix measured value above measuring range in Pepperl+Fuchs R1000?
If the measured value from your Pepperl+Fuchs Accessories device is above the measuring range, it means the reflector is too far from the device. You should position the reflector within the specified measuring range. Refer to the datasheet for detailed information on the measuring range.
What to do if Pepperl+Fuchs R1000 Accessories measured value is below measuring range?
If your Pepperl+Fuchs Accessories device shows a measured value below the measuring range, the reflector is likely too close to the device. Adjust the position of the reflector to be within the correct measuring range, consulting the datasheet for specifics.
Why Pepperl+Fuchs R1000 Accessories shows negative measured value?
A negative measured value on your Pepperl+Fuchs Accessories device indicates that the sum of the absolute measured value and the user-defined offset is negative. To fix this, correct the offset value.
General| Brand | Pepperl+Fuchs |
|---|---|
| Model | R1000 Series |
| Category | Accessories |
| Language | English |
To Next Page
