Pepperl+Fuchs UC2000-L2-E6-V15 - User Manual

Germany: +49 621 776 4411Pepperl+Fuchs Group
Refer to “General Notes Relating to Pepperl+Fuchs Product Information”.
USA: +1 330 486 0001 Singapore: +65 6779 9091
www.pepperl-fuchs.com fa-info@us.pepperl-fuchs.com fa-info@sg.pepperl-fuchs.com
fa-info@de.pepperl-fuchs.com
1
Ultrasonic sensor UC2000-L2-E6-V15
Release date: 2014-01-08 10:03 Date of issue: 2014-01-08 188202_eng.xml
Technical data
General specifications
Sensing range 60 ... 2000 mm
Adjustment range 80 ... 2000 mm
Unusable area 0 ... 60 mm
Standard target plate 100 mm x 100 mm
Transducer frequency approx. 175 kHz
Response delay ≤ 100 ms
Indicators/operating means
LED green Operating display
LED yellow 1 switching state switch output 1
LED yellow 2 switching state switch output 2
LED red error
Electrical specifications
Operating voltage U
B
10 ... 30 V DC , ripple 10 %
SS
No-load supply current I
0
≤ 50 mA
Interface
Interface type Serial interface (programming adapter required)
9600 BPS, no parity, 8 data bits, 1 stop bit
Input/Output
Input/output type 1 synchronization connection, bidirectional
0 Level 0 ... 1 V
1 Level 4 V ... U
B
Input impedance > 12 kΩ
Output rated operating current < 12 mA
Pulse length 0.5 ... 300 ms (level 1)
Pulse interval ≥ 33 ms (level 0)
Synchronization frequency
Common mode operation ≤ 30 Hz
Multiplex operation ≤ 33 Hz / n , n = number of sensors , n ≤ 10
(factory setting: n = 5 )
Output
Output type 2 switch outputs PNP, NO/NC, programmable
Rated operating current I
e
200 mA , short-circuit/overload protected
Voltage drop U
d
≤ 2 V
Repeat accuracy ≤ 0.1 % of full-scale value
Switching frequency f ≤ 5 Hz
Range hysteresis H programmable , preset to 1 mm
Temperature influence < 1.5 % of full-scale value
Ambient conditions
Ambient temperature -25 ... 70 °C (-13 ... 158 °F)
Storage temperature -40 ... 85 °C (-40 ... 185 °F)
Mechanical specifications
Connection type Connector M12 x 1 , 5-pin
Protection degree IP67
Material
Housing PA-GF35
Transducer epoxy resin/hollow glass sphere mixture; polyurethane foam
Mass 115 g
Factory settings
Output 1 near switch point: 80 mm
far switch point: 2000 mm
output function: Window operation mode
output behavior: NO contact
Output 2 near switch point: 150 mm
far switch point: 1000 mm
output function: Window operation mode
output behavior: NO contact
Beam width wide
General information
Supplementary information Switch settings of the external programming adapter:
"output load": pull-down
"output logic": inv
Compliance with standards and
directives
Standard conformity
Standards EN 60947-5-2:2007
IEC 60947-5-2:2007
Approvals and certificates
UL approval cULus Listed, General Purpose
CSA approval cCSAus Listed, General Purpose
CCC approval CCC approval / marking not required for products rated
≤36 V
Model Number
UC2000-L2-E6-V15
Single head system
Features
• Sensor head bidirectional and ro-
tatable
• Function indicators visible from all
directions
• Quick mounting bracket
• Selectable sound lobe width
• Programmable
Diagrams
0 400 800 1200 1600 2000 2400 2800 32003200 3600 4000
700
600
500
400
300
200
100
0
-100
-200
-300
-400
-500
-600
-700
X
Y
Characteristic response curve
Distance X [mm]
Distance Y [mm]
flat surface 100 mm x 100 mm
round bar, Ø 25 mm
wide sound lobe
narrow sound lobe

Summary

Technical Data

General Specifications

Overview of sensor operational parameters like sensing range, adjustment, and response.

Electrical Specifications

Details on voltage, current, and interface type for sensor operation and connection.

Input;Output

Defines voltage levels, impedance, output current, and pulse parameters for sensor I/O.

Output

Specifies output types (PNP), current ratings, voltage drop, accuracy, and operational limits.

Mechanical Specifications

Covers connection type, IP rating, housing material, and sensor weight.

Ambient Conditions

Details the operating and storage temperature ranges for the sensor.

Compliance with Standards and Directives

Lists conformity with EN 60947-5-2 and IEC 60947-5-2 standards.

Approvals and Certificates

Lists relevant product approvals and certifications like UL, CSA, and CCC.

Features

Sensor Head Bidirectional and Rotatable

Highlights the sensor head's ability to rotate for flexible positioning.

Selectable Sound Lobe Width

Indicates the capability to adjust the sensor's sound beam width.

Programmable

States that the sensor's functions and settings are programmable.

Dimensions

Electrical Connection

Pinout

Accessories

Programming Procedure

Programming the Switch Points

Guides on setting near and far switch points for sensor outputs.

Programming Modes of Operation

Details programming output function, behavior, and beam width.

Display

Synchronization

Synchronization Modes

Describes various modes for synchronizing multiple sensors to avoid interference.

Pepperl+Fuchs UC2000-L2-E6-V15 Specifications

General

Series	UC2000
Type	Ultrasonic Sensor
Operating Voltage	10 ... 30 V DC
Connection Type	Cable
Cable Length	2 m
Protection Class	IP67
Housing Material	Plastic
Output Type (Digital)	NPN
Ambient Temperature Range	-25 ... +70 °C