How-to Document
PePWave Surf AP 200 and 400
Wirelessly Connecting a Home Network 1 Copyright © 2007 PePWave Ltd.
Wirelessly Connecting a Home Network with PePWave Surf AP 200 and 400
I n t e g r a t e d H o m e W i - F i A c c e s s P o i n t S e t u p G u i d e
Overview
This guide presents a brief introduction, and a step-by-step process, to
configure a basic setup for the Integrated Home Wi-Fi Access Point
functionality of PePWave Surf AP 200 and 400.
Prior to carrying out the setup procedure in this
guide, the process of connecting PePWave Surf
AP 200/400 with Citywide Wi-Fi must have been
successfully performed.
The high-level steps are as follows:
1. Set up Integrated Home Wi-Fi Access
Point on PePWave Surf AP 200/400
2. Configure Wi-Fi enabled host PC(s)
3.
Test the Wi-Fi connection(s) with PePWave Surf AP 200/400
Integrated Home Wi-Fi Access Point – Introduction
Integrated Home Wi-Fi Access Point functionality of PePWave Surf AP 200/400 allows
802.1b/g devices on customers’ premises to wirelessly connect with a PePWave Surf
AP 200/400 unit through which Citywide Wi-Fi is accessed. With PePWave Surf AP
200/400, the already existing Ethernet capabilities of the PePWave Surf Series
remain unaffected.
Figure 1 – PePWave Surf AP 200/400 and Integrated Home Wi-Fi Access Point
To Next Page
Need help?
General
