How-to Document
PePWave Surf AP 200 and 400
Wirelessly Connecting a Home Network 5 Copyright © 2007 PePWave Ltd.
3. Select the entry for MySSID@home.
4. Click Connect at the bottom-right corner of the Wireless Network
Connection window. A dialog box then prompts for the Network Key.
5. In the Network key field, enter the value that was previously entered as the
Encryption Key when configuring the AP Settings of PePWave Surf AP
200/400. (The value PePWaveSurfAP was previously used in this guide for
illustration.)
6. In the Confirm key field, enter the same value as in the previous step.
7. Click Connect at the bottom-right corner of the dialog box.
Testing the Wi-Fi Connection(s)
Test the Wi-Fi connection between the newly configured Wi-Fi enabled host PC and
PePWave Surf AP 200/400 as follows:
1. Disconnect the Ethernet cable from the host PC.
2. Connect through a web-browser with the Web-based Configuration Interface
of PePWave Surf AP 200/400, via the URL http://192.168.20.1
Upon successfully connecting, the Welcome Screen is displayed.
After successfully testing the connection between the Wi-Fi enabled host PC and
PePWave Surf AP 200/400, test the connection with the Internet by visiting our
website at www.pepwave.com.
PePWave Technical Support
In the event that, after carrying out the setup procedure, the Integrated Home Wi-Fi
Access Point component of PePWave Surf AP 200/400 fails to function, please browse
the PePWave website at www.pepwave.com for additional information, or contact
PePWave Technical Support via email at support@pepwave.com.
To Previous Page
Loading...
