How-to Document
PePWave Surf AP 200 and 400
Wirelessly Connecting a Home Network 2 Copyright © 2007 PePWave Ltd.
Important Note: Prerequisite Setup
In order to configure, and subsequently test, the Integrated Home Wi-Fi Access Point
functionality of PePWave Surf AP 200/400, connectivity between the PePWave Surf AP
200/400 unit and Citywide Wi-Fi must have already been established.
A guide through this “Prerequisite Setup” process to connect PePWave Surf AP 200/400
and Citywide Wi-Fi is available from the PePWave website, as follows:
Wi-Fi Connection Setup Guide – PePWave Surf How-to Document
http://www.pepwave.com/document/PePWave_Surf_howto_connection_setup_guide.pdf
Setup Procedure
Integrated Home Wi-Fi Access Point Configuration
From the configuration and connections performed in the Prerequisite Setup, the
Web-based Configuration Interface of PePWave Surf AP 200/400 should remain
accessible via a host PC connected via Ethernet to the PePWave Surf AP 200/400
unit.
Configure the Integrated Home Wi-Fi Access Point settings as follows:
1. Connect through a web-browser with the Web-based Configuration Interface
of PePWave Surf AP 200/400, via the URL http://192.168.20.1
Upon successfully connecting, the Welcome Screen is displayed.
Figure 2 – PePWave Surf Web-based Configuration Interface Welcome Screen
2. Click on Advanced Config. This loads the CPE Setup page, where the Wi-Fi
settings are configured. (On the CPE Setup page, configuration parameters
in the section AP Settings will need to be modified, whereas the other
settings will remain at the values configured in the Prerequisite Setup.)
To Next Page
Loading...
