How-to Document
PePWave Surf AP 200 and 400
Wirelessly Connecting a Home Network 4 Copyright © 2007 PePWave Ltd.
4. In the AP SSID field, enter an alphanumeric value by which the home Wi-Fi
network is to be identified. For illustration purposes, the default AP SSID
value MySSID@home will be used throughout this guide.
5. Select WPA/WPA-2-Personal from the Authentication drop-down menu.
6. In the Encryption Key field, enter an alphanumeric value that is difficult to
guess, and contains at least 8 characters. The same value as the one
entered here will subsequently be used when configuring host PC(s) that
connect with Integrated Home Wi-Fi Access Point of PePWave Surf AP
200/400. For illustration purposes, the encryption key value
PePWaveSurfAP will be used throughout this guide.
7. Click Save at the bottom-right corner of the CPE Setup page.
Configuration of Wi-Fi Enabled Host PC(s)
From a Wi-Fi enabled Windows XP host PC, connect with the Integrated Home Wi-Fi
Access Point of PePWave Surf AP 200/400 as follows:
1. Make the following menu selections:
Start Menu > Control Panel > Network Connections
2. From Network Connections, right-click on the Wireless Network
Connection icon, then select View Available Wireless Networks. The
Wireless Network Connection window appears, as illustrated in Figure 5.
Figure 5 – Windows XP dialog box for connecting to a wireless network
An entry for MySSID@home should be present in the list of available
wireless networks. If the entry is absent, click on Refresh network list on
the left-hand side of the Wireless Network Connection window.
The entry for MySSID@home should be present afterwards.
To Next Page
Loading...
