Built-In Remote User VPN Support
Use OpenVPN or L2TP with IPsec to safely and conveniently connect remote clients to your
private network. L2TP with IPsec is supported by most devices, but legacy devices can also
connect using PPTP.
Click here for the full instructions on setting up L2TP with IPsec.
(http://www.peplink.com/knowledgebase/setting-up-l2tp-with-ipsec/)Click here for the full
instructions on setting up OpenVPN connections (https://forum.peplink.com/t/configure-remote-
user-access-using-openvpn/19757)
DPI Engine
The DPI report written in the updated KB article will show further information on InControl2
through breaking down application categories into subcategories.
sscs
https://forum.peplink.com/t/updated-ic2-deep-packet-inspection-dpi-reports-and-everything-you-
need-to-know-about-it/29658 (https://forum.peplink.com/t/updated-ic2-deep-packet-inspection-
dpi-reports-and-everything-you-need-to-know-about-it/29658)
Wi-Fi Air Monitoring
Pepwave routers support Wi-Fi “Air Monitoring Mode” which used to troubleshoot remotely and
proactively monitor Wi-Fi and WAN performance. The report can be viewed under InControl 2 >
Reports > AirProbe Reports after enabling Wi-Fi Air Monitoring.
Note: To enable this feature, go to https://<Device’s IP>/cgi-bin/MANGA/support.cgi
To Next Page
Loading...
