Reboot
This page provides a reboot button for restarting the system. For maximum reliability, the
Pepwave router can equip with two copies of firmware. Each copy can be a different version. You
can select the firmware version you would like to reboot the device with. The firmware marked
with
(Running)
is the current system boot up firmware.
Please note that a firmware upgrade will always replace the inactive firmware partition.
Ch. 20 Tools
Ping (https://manual.peplink.com/documentation/ping/)
Traceroute Test (https://manual.peplink.com/documentation/pepwave-surf-soho-user-
manual/ch-19-tools/traceroute-test/)
Wake-on-LAN (https://manual.peplink.com/documentation/pepwave-surf-soho-user-
manual/ch-19-tools/wake-on-lan/)
WAN Analysis (https://manual.peplink.com/documentation/pepwave-surf-soho-user-
manual/ch-19-tools/wan-analysis/)
Ping
The ping test tool sends pings through a specific Ethernet interface or a SpeedFusion™VPN
connection. You can specify the number of pings in the field
Number of times
, to a maximum
number of 10 times.
Packet Size
can be set to a maximum of 1472 bytes. The ping utility is
located at
System > Tools > Ping
,
illustrated below:
To Next Page
Loading...
