Wake-on-LAN
Peplink routers can send special “magic packets” to any client specified from the Web UI. To
access this feature, navigate to
System > Tools > Wake-on-LAN.
Select a client from the drop-down list and click
Send
to send a “magic packet”
WAN Analysis
The WAN Analysis feature allows you to run a WAN to WAN speed test between 2 Peplink devices .
You can set a device up as a
Server
or a
Client
. One device must be set up as a server to run the
speed tests and the server must have a public IP address.
The default port is 6000 and can be changed if required. The IP address of the WAN interface will
be shown in the
WAN Connection Status
section.
To Next Page
Loading...
