Layer 2 SpeedFusion VPN Bridging
SpeedFusion VPN
Profiles to Bridge
The remote network of the selected PepVPN profiles will be bridged
with this local LAN, creating a Layer 2 PepVPN, they will be connected
and operate like a single LAN, and any broadcast or multicast packets
will be sent over the VPN.
Spanning Tree
Protocol
Click the box will enable STP for this layer 2 profile bridge.
DHCP Option 82
Injection
Click on the question Mark if you want to enable DHCP Option 82.
This allows the device to inject Option 82 with Router Name
information before forwarding the DHCP Request packet to a PepVPN
peer, such that the DHCP Server can identify where the request
originates from.
Override IP Address
when bridge
connected
Select “
Do not override
” if the LAN IP address and local DHCP server
should remain unchanged after the Layer 2 PepVPN is up.
If you choose to override IP address when the VPN is connected, the
device will not act as a router, and most Layer 3 routing functions will
cease to work.
DHCP Server Settings
To Next Page
Loading...
